Removal Timing Belt(Esteem)
1. Disconnect negative battery cable. Remove right side engine under cover. Remove power steering and A/C compressor drive belts. 2. Remove A/C compressor and power steering pump with hoses attached, and secure out of way. Support engine from above or with floor jack under oil pan. Remove air cleaner case with air cleaner outlet hose. 3. From timing belt end of engine, remove engine mount and mounting bracket. Loosen water pump pulley bolts. Remove water pump drive belt and pulley. 4. Remove 5 crankshaft pulley-to-crankshaft bolts. Remove pulley. It is NOT necessary to remove crankshaft center bolt. Remove timing belt cover. See Fig. 1 . 5. Rotate crankshaft clockwise to align timing marks. See Fig. 2 and Fig. 3 . Stamped “E” on camshaft sprocket must point straight up. Loosen timing belt tensioner bolt and stud nut. Move tensioner away from belt, and hand tighten bolt and nut. See Fig. 4 . 6. If reusing old belt, mark belt with an arrow indicating direction of rotation for installation reference. Remove timing belt.
(more…)

• 0 Comments

This pdf covers the removal & installation the timing case cover for Chevrolet S10 Pickup.
Removal
1. Disconnect negative battery cable. Remove P/S reservoir from radiator shroud. Remove upper fan shroud. Remove serpentine belt.
2. Remove generator with brackets and lay aside. Using Hub Puller (J-24420-B), remove crankshaft pulley hub. Remove oil pan. See OIL PAN. Remove front timing case cover bolts, and cover.
3. Using large screwdriver, remove crankshaft front seal. DO NOT distort timing gear cover during seal removal.
CAUTION: To prevent oil leakage, coat crankshaft pulley hub keyway with RTV sealant before installation.
(more…)

• 0 Comments

Removal (Frontier, Pathfinder, QX4 & Xterra)
1. Disconnect negative battery cable. Remove the engine undercover. Drain coolant and remove the radiator.
Remove engine cooling fan and water pump pulley. Remove accessory drive belts. Remove spark plugs.
2. Remove distributor protector. Remove A/C compressor drive belt idler bracket. Remove fresh air intake
tube from rocker cover. Remove thermostat housing hose.
3. Rotate crankshaft to set No. 1 cylinder at TDC on compression stroke. See Fig. 1 . Remove crankshaft
pulley bolt and remove crankshaft pulley. Remove front upper and lower timing belt covers. See Fig. 2 .
4. Align punch mark on left camshaft sprocket with punch mark on timing belt upper rear cover. Align
punch mark on crankshaft sprocket with notch on oil pump housing. See Fig. 3 . Install crankshaft pulley
bolt so that crankshaft can be rotated.
(more…)

• 0 Comments