Entries Tagged as 'crease'

Upper Windshield Glass Stoppers: 1. Remove both sun visors and both A-pillar garnishes, and then carefully lower the front of the headliner to gain access to the windshield stoppers (refer to the appropriate model year Repair Manual for the proper procedure). NOTE: It is very important that the front of the headliner be lowered carefully and slowly. Applying too much downward force on the headliner will cause it to develop a permanent crease in the surface material. The stoppers are located on the inside of the passenger compartment behind the windshield glass (more…)

Detailed Instructions
1 Check off all items against Snorkel Kit List.
2 Remove guard liner, front rubber and windscreen washer reservoir.
3 Tape Template together accurately on gridline 17. Cut down grid line 28 to mark.
4 Place the Airflow Template supplied on the guard, ensuring the guard crease line are followed exactly. The top guard edge line is a guide only as it will vary slightly between pre and post 1997 cherokee’s.
5 Tape over the sites of all hole points to protect the guard. Locate holes as indicated and mark with centre punch. Drill the 8mm holes. Be careful of any wires or other obstructions under the inner guard.
(more…)

- 2000 Dodge Cummins MAP sensor - 2000 Dodge Cummins MAP sensor - 1997 pathfinder timing belt mark - connect mirror dimmer e36 - connect mirror dimmer e36 - webasto octavia 2 - Fiat Ducato X250 repair manual - webasto octavia 2 - webasto octavia 2 - nissan micra immobiliser wiring - 430n ipod - 430n ipod - 430n ipod - camshaft seal removal tool suzuki sidekick - st185 gearbox maxtorque