Installation Procedure:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner
3. Using 1/2” socket, remove (3) 5/16’ bolts.
* Please Note: Some units have bolts that are drilled and tapped for air cleaner mounting studs.
4. It is not necessary to remove the fuel lines.
5. Remove fuel line bracket from transmission. (Located on drivers side of bell housing)
(more…)

• 0 Comments

Installation Instructions Procedures:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
(more…)

• 0 Comments

Installation Procedure for this body spacer:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (2) nuts from the throttle body and (2) studs from manifold. (Ref. “C”)
4. Remove gasket and clean surfaces.
(more…)

• 0 Comments

The installation instructions step:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner housing from throttle body.
3. Remove 5/16” bolt (Ref. “C”) & stud (Ref. “D”) from throttle body.
4. Remove (2) 6mm bolts from throttle linkage bracket and save.
5. Move the throttle body forward then remove the gasket and clean the surfaces.
(more…)

• 0 Comments