Entries Tagged as 'cup holder'

This manual contains the pre-installation, assembly and installation for dual player headrest video on Toyota Prius 2010.
Pre-installation Precaution
1. Use Seat and Floor Protectors to avoid damage to surfaces.
2. If the vehicle is equipped with an Anti-theft radio, the radio code must be written down prior to disconnecting the battery cable. The code must be re-entered when the negative battery cable is reinstalled. Disconnecting the battery
Figure may cause certain vehicle settings to be lost. Manufacture’s recommendations for the battery B3 removal should be followed. Disconnecting the battery is recommended.
(more…)

STEP 1. Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece. Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do not disconnect the wiring . STEP 2. Under the temperature control module is a small black panel that is held in (more…)

- 2000 Dodge Cummins MAP sensor - 2000 Dodge Cummins MAP sensor - 1997 pathfinder timing belt mark - connect mirror dimmer e36 - connect mirror dimmer e36 - webasto octavia 2 - Fiat Ducato X250 repair manual - webasto octavia 2 - webasto octavia 2 - nissan micra immobiliser wiring - 430n ipod - 430n ipod - 430n ipod - camshaft seal removal tool suzuki sidekick - st185 gearbox maxtorque