This manual is divided into different areas to assist you with your installation and operation of your steering box support system. This product is not a replacement for a new steering box and/or ball joints, but it will aid in reducing the stress placed on the steering box and associated wear. All steering components should be checked and replaced if necessary prior to addition of the steering box support. Installation should occur on a vehicle properly secured to prevent rolling. Application of lubrication at regular chassis lube intervals will promote bearing life.
(more…)

• 0 Comments

Toothed Belt Special tools, testers and auxiliary items required Engine support bridge 10-222 A ( guide 10-222 A/21 changing ) Adapter 10-222 A/8 Torque wrench V.A.G 1331 Torque wrench V.A.G 1332 Pin wrench T10020 Changing the Engine Support Bridge 10-222 A . Guide 10-222 A/21 The engine support bridge 10-222 A is needed to support the engine/transmission subassembly. A new bore is required for securing the adapter 10-222 A/8 to the guide 10-222 A/21 . Dimensions in mm. Drill a 12.5 mm diameter hole – arrow – into the guide 10-222 A/21.
(more…)

• 0 Comments

Requirements for proper installation
1. Use copper or brass fittings only. (NEVER USE GALVANIZED FITTINGS)
2. The water inlet and steam outlet need brass unions for easy removal.
3. The Generator must be upright, accessible, and on a level surface.
4. Unit may be installed up to 25 feet away from shower area.
5. Do not use ABS PVC or any plastic material for the steam line.
6. Do not plumb a trap in the steam line.
7. Pitch steam line back towards generator and avoid perfectly level plumbed lines.
(more…)

• 0 Comments

This Fast Response Circuit is designed specifically for use with DODGE D-Series Motor Brakes. It will allow the brake to provide a faster drop out time (time to braking). Part number 031386 is for use with 115/230 VAC brake coils. Part number 031389 is for use with 230/460 VAC brake coils.
(more…)

• 0 Comments

Read instructions before assembling. Fasteners should be finger tight until instructed to tighten according to the torque chart. Use standard methods and practices when attaching snowplow including proper personal protective safety equipment.

INSTALLATION INSTRUCTIONS
NOTE: For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete.
1. Remove license plate bracket and retain for vehicle owner. Remove bumper from bumper brackets. Retain fasteners.
(more…)

• 0 Comments

Instructions:
1. Remove the stock GM 245mm impeller hub by boring a 3.380″/3.385″ diameter hole on center in the stock GM 245mm impeller (see Figure 1).
2. Install the Sonnax CH-90CM-27 impeller hub from the outside. Weld around the OD of the impeller hub, making sure it is centered in the impeller. This weld must be leak-proof (see Figure 2).
3. Once the impeller hub is fitted, fixture the impeller assembly in the lathe. Turn the lip of the impeller so that it is 3.80″ from the end of the impeller hub. Then turn the OD down to 10.150″/10.145″ diameter, .40″ from the end (see Figure 3).
4. Install the adapter ring on the impeller assembly as shown in Figure 4 and weld around the OD of the impeller. This weld must be leak-proof.
(more…)

• 0 Comments