FRONT INSTALLTION INSTRUCTIONS
1. Block the rear wheels of the vehicle. Raise the front of the vehicle and support the vehicle with jack stands under the frame rails. Remove the front wheels and tires and set aside. Position a hydraulic jack under the front axle and raise the jack until the front suspension begins to compress.
2. On both sides of the vehicle, scribe alignment marks on the adjustment cam and axle bracket at the lower link to axle attachment point for later reference. See Photo 1
(more…)

• 0 Comments

Please read instructions thoroughly and completely before beginning installation. Installation by a trained mechanic is recommended
Step 1: Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available and remove the front wheels and tires
Locate the front sway bar and unbolt the lower end link. (Do this on both sides of vehicle).
Next locate the lower track bar mount on the passenger side of the vehicle and unbolt from axel.
Step 2: Place an index mark on the stock coil and a matching one on the lower coil pocket . This will allow you to replace the coils in the stock location Next locate the upper shock mounts (they are located in the engine compartment) and remove the upper shock hardware. Next remove the 3 nuts from the upper shock mounts (Do this on both sides of truck). Now remove the lower shock mounting bolts and remove the shocks by pulling them up through the engine compartment. (Do this on both sides of truck)
(more…)

• 0 Comments