The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
1. Allow the engine and all cooling system components to cool down.
2. Place a clean drain pan under the radiator drain plug, then remove the drain plug from the bottom of the radiator to drain the coolant. Remove the radiator cap to increase the flow.
(more…)

• 0 Comments

The Mag-Hytec pan is designed to fit the factory Dodge #727 transmission body as supplied as original equipment. However, in some applications, or because of the use of certain factory options and/or after market equipment, there may be clearance problems between your Mag-Hytec pan and other vehicle components. It is the responsibility of the vehicle owner and installer to ensure that there is no contact between the pan and other moving or fixed vehicle components. Contact with any vehicle component or the modifying of the Mag-Hytec pan voids the warranty. Mag-Hytec assumes no liability, expressed or implied, for damage or injury to persons or property.
(more…)

• 0 Comments

Installation Procedure:
1. Remove truck bed
2. Chalk front tires to ensure truck does not roll.
3. Jack rear of truck up at FRAME RAIL and secure with jack stand at REAREND. Duplicate on both sides. Remove wheels, shocks, sway bar and mounts. When finished rear of truck should be suspended by 2 jack stands on axle with wheels removed and suspension STILL INTACT.
4. Using FRAME SECTION as guide, place FRAME SECTION next to outside of truck frame rail to check for clearances of rivets, tabs, and brackets etc. that will impede the FRAME SECTION from sliding onto frame rail.
5. Remove and/or relocate any rivets, tabs, brackets etc.
6. Slide FRAME SECTION over frame rail into place, it will be a tight fit and usually will need help with a mallet to knock onto frame rail.
7. Repeat steps 4 through 6 on opposite side.
8. With FRAME SECTION in place mount REAR CROSS MEMBER to top rear of notch next to upper bag placement. Loosely bolt REAR CROSSMEMBER in place to allow movement.
(more…)

• 0 Comments