READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), 10mm socket and driver, #2 Phillips screwdriver.
PARTS INCLUDED: One phone mount , Three (3) #8×3/4” self tapping screws
LOCATION OF MOUNT: To the right of the radio
(more…)

• 0 Comments

The Volkswagen Transporter Shuttle is available in 3 specification models and offer high quality and affordable travel solutions for one adult or child wheelchair dependant passenger with ease of access to the vehicle with either help or independently. The Shuttle has been designed to carry 3 seated and 1 wheelchair passengers and offers an excellent level of comfort, flexibility and space for both driver and passengers. The Volkswagen Transporter Shuttle is supplied with independent rear heating for the coldest day, electrically adjustable & heated windows & mirrors, rear passenger compartment heater and side sliding doors on both sides with sliding windows. We normally supply a new Volkswagen Transporter Shuttle, however we can carry out a conversion on the vehicle supplied by you.
(more…)

• 0 Comments

GUARDIAN MODULE – Remove drivers seat and step-well trim for access. Guardian module should be mounted inside seat pedestal. It can be secured using self-tapping screws or wire ties. Do not secure the module until all harnesses are installed and proper lift operation has been verified.

LED DISPLAY PANEL – This harness can be identified by the blue tape near the 6-pin connector. Locate a suitable position on the dashboard within clear view of the driver for the mounting of the LED Display Panel. LED display harness will be routed under step-well trim (See Fig 2). Drill a ū” hole in the dashboard where you wish the center of the display to be. Snap the blue taped end of the LED display harness into the Guardian Module in the connector labeled in blue “Display”. Run the other end of the harness under the step-well and dash area then through the ū” hole. Snap the other end of the LED display harness into the LED Display Panel. Ensure panel is level, and secure using the supplied screws.
(more…)

• 0 Comments

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: #2 Phillips screwdriver, 5/64” drill bit, drill, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM, instructions, two (2) #10×5/8” screws.
LOCATION: Lower right corner of radio, below the radio.
(more…)

• 0 Comments

READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever you are removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break
(more…)

• 0 Comments

All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
Locate four slots on the face of the radio. Insert four Audi DIN tools in these four slots until you hear or feel the tools click or lock.
(more…)

• 0 Comments