READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), 10mm socket and driver, #2 Phillips screwdriver.
PARTS INCLUDED: One phone mount , Three (3) #8×3/4” self tapping screws
LOCATION OF MOUNT: To the right of the radio
(more…)

• 0 Comments

STEP 1. Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece. Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do not disconnect the wiring . STEP 2. Under the temperature control module is a small black panel that is held in (more…)

• 0 Comments

INSTALLATION
1. Remove the four screws mounting the hood release under the dash.
2. Move hood release assembly 3/4” toward the passenger side of the vehicle and re-mount using the three #10 self-tapping screws provided. Note: The larger hole in the dash mount will not be reused. (Fig. 2)
3. Place the supplied dash bracket between the hood latch and the emergency brake release. Bend the dash bracket so it is parallel to the firewall (Fig. 2). The amount of bend may vary. Note: to protect the finish, place the bracket between two small blocks of wood in a vice and tap down with a soft face hammer or lift with non-marring tool.
(more…)

• 0 Comments

Installation of a Performance Automotive Group body lift kit will change the vehicle’s center of gravity and handling characteristics both on- and off-road. You must drive the vehicle safely! Extreme care must be taken to prevent vehicle rollover or loss of control, which could result in serious injury or death. Avoid sudden sharp turns or abrupt maneuvers and always make sure all vehicle occupants have their seat belts fastened.
(more…)

• 0 Comments

The Instrument Cluster contains sensitive electronic components. Great care should be taken when working around or handling electronic components. Avoid touching components on a circuit board directly. Static shock could damage these components. Avoid working in areas that can create excessive static shock such as carpeted rooms.
1. First disconnect the Negative (-) Battery Terminal and apply the Emergency Brake.
2. Remove the instrument cluster trim by the following steps.
(more…)

• 0 Comments