Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover. Data Link Connection
2. The Data Link connector is located in different locations based on the
year of the truck:
• 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump
• 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump
3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector.
(more…)

• 0 Comments

The AEM Cold Air System is the result of extensive development on a wide variety of cars. Each system is engineered for the particular application. The AEM Cold Air System differs from all others in several ways. We take the inlet air from outside of the engine compartment where the inlet air is considerably cooler than the hot underhood air. The cooler inlet air temperature translates to more power during the combustion process because cool air is denser than warm air. AEM has conducted extensive inlet air temperature studies and we have seen temperature reductions of up to 50 degrees by pulling air from outside of the engine compartment. The air mass flow to the engine is increased because of the increased airflow and reduced inlet temperature, which translates to more power. The AEM Cold Air Systems are 50 states Street Legal (some models and years still pending) and come with complete instructions for ease of installation.
(more…)

• 0 Comments