1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the radio trim panel including the a/c vent. (Figure A) 3 Remove (4) 10 MM bolts securing the radio. Unplug and remove the radio.
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS
*Note: Refer also to the instructions included with the aftermarket radio.
1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel. (Figure A)
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
(more…)

• 0 Comments

Dash Assembly: 1 Disconnect the negative battery-terminal to prevent an accidental short circuit. 2 Unsnap the trim below the climate control to reveal (2) 10 MM bolts and remove. (Figure A) 3 Carefully pull air vents above radio towards rear of car to unsnap. NOTE: There are (3) snaps, (2) are at the bottom sides and (1) is at the top middle of the vent assembly. (Figure B) 4 Remove (2) 10 MM bolts from above radio/climate control assembly. Unplug and remove assembly together. (Figure C) 5 Remove (6) Phillips screws (4 from radio and 2 from climate control) from each side bracket to separate radio and climate control. (Save climate controls and brackets to reuse during kit assembly). (Figure D) Continue to kit assembly.
(more…)

• 0 Comments

Moroso Crankshaft Wipers are designed so that they can be trimmed to fit the widest possible range of counter-weight, rod/stroke configurations. They are to be mounted to the starter side of the block only. The Moroso Crankshaft Wiper is engineered to clear assemblies down to 2.9 IN. of stroke using stock type rods. As the stroke is increased and /or larger rods used, the amount of material to be removed increases. Do not be alarmed at the amount of grinding and trimming with shears which may be necessary to clear your particular assembly. We recommend.030” to .045” clearance around all moving components. After you have trimmed your wiper, be sure to smooth all edges to prevent all potential engine damage due to burrs vibrating off into the crankcase. Before final assembly, double check for clearance when the crankshaft is rotated a full 360 degrees. Be sure to account for “thrust end play” while checking for proper clearance. After final fitting and deburring, cement the wiper to the block. You can use contact cement or weather-strip adhesive (An alternate method would be to use tiny flat head screws or pinning). Next, install the pan gaskets in the usual manner. Due to the slightly increased height on one side,
Be sure to use a dab of silicone in the corners where the rubber ends meet the side rail gaskets.
(more…)

• 0 Comments

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unclip and remove the center console trim panel. (Figure A)
3. Unclip the center dash trim panel.
4. Remove (4) screws securing the radio. Disconnect and remove the radio.
5. Remove (3) screws securing the radio rear support bracket and remove the bracket.
(more…)

• 0 Comments