You will have bolts/nuts left over. There are several vehicle arrangements and we have provided the hardware for each configuration.
STEP ONE: Determine proper bracket placement.
1) Find the pre-existing holes equally spaced on the pinch weld.
2) Factory mounting holes have changed throughout model years and will require one of the following. ( Fig A & B )
(more…)

• 0 Comments

Installation Stainless Steel Oval on Dodge RAM HD Crew Cab:
1. Read instructions completely and check to make sure that all required parts (listed on service parts list) are on hand before starting the installation.
2. Oval step assemblies and brackets (item #1 & 2) are pre-assembled.
2.1. The front and rear mounting brackets on these assemblies are rotated for shipping purposes. These brackets must be rotated to the vertical position and the ‘/2″ bolts. Torque to 65 lb ft.
(more…)

• 0 Comments

- Stock air intake cleaner and air ducts shown in this picture. Before getting started with the installation, disconnect the negative battery terminal and remove the strut tower bar from the engine compartment.
- Loosen and remove the 3- 14mm bolts and 1- nut shown on the passenger side.
- Remove the 3- m14 bolts and 1- flange nut located on the drive side strut bar bracket.
- Once all 6- 14mm bolts and two flange nuts have been removed, continue to pull the strut tower bar out of the engine compartment.
- Removing engine covers: Remove the 2- 10mm flange nuts and the 2-10mm bolts from the lower engine cover.
(more…)

• 0 Comments

Introduction: Remove/Install rear sub-frame bushes in Mondeo. Can be used in situ – no need to remove sub-frame from vehicle. Applications: Ford Mondeo 2001, 10/2000 onwards
3.1 Ensure that the vehicle is adequately supported on axle stands before working under the vehicle.
3.2 Although there is no need to remove the sub-frame from the vehicle it will be necessary to lower it to gain access to both sides of the bush housing.
(more…)

• 0 Comments

Installation Instructions Procedures:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
(more…)

• 0 Comments