Please Note: It is preferable to park on a flat surface, as you will have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the short shifter on a slightly inclined surface, place wooden blocks in front and behind the wheels to prevent the car from moving while you’re working. Please read this manual completely before beginning to work on your car.
Estimated Installation Time: 60 minutes shifter only, 75 minutes with base bushings
(more…)

• 0 Comments

1. Remove the stock shift knob and boot cover.
2. Carefully slide an exacto knife under the clip on the right side of the assembly to remove it. CAUTION : Be extremely careful in this step, if the knife is torqued too hard the blade could break and become a dangerous projectile.
3. Insert a flat head screw driver into the gap created by the exacto knife to pry the clip off.
4. Use a punch to drive out the pin on the opposite side of the shifter. Tap lightly with a hammer until the pin is driven out of the assembly.
5. Remove the four bolts securing the plastic assembly to the chassis.
(more…)

• 1 Comment

Please Note: It is preferable to park on a flat surface, as you will have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the short shifter on a slightly inclined surface, place wooden blocks in front and behind the wheels to prevent the car from moving while you’re working. Please read this manual completely before beginning to work on your car. Estimated Installation Time: 60 minutes shifter only, 75 minutes with base bushings
(more…)

• 0 Comments

Installation Instructions Procedures:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
(more…)

• 0 Comments