Removal, overhaul and installation procedures are covered in this article. If component removal and installation is primarily an unbolt and bolt-on procedure, only a torque specification may be furnished.
NOTE: Mirage 1.6L uses Distributorless Ignition System (DIS). For exploded view of distributor on all other models,
FUEL SYSTEM
WARNING: Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.
(more…)

• 0 Comments

This manual contains dismantling data for the following vehicles: MODEL YEAR MAKE MODEL VARIANT ENGINE TRANSMISSION 2007 Chevrolet Trailblazer 4×4 4.2L L6 4L60E
Provide additional support when a vehicle is on a hoist in the following ways:
• Before removing parts, support the opposite end. This helps prevent the vehicle from slipping off.
• Before removing major components, chain the vehicle frame to the hoist pads at the same end as the removal. This helps avoid a tip-off. (more…)

• 0 Comments

This manual concerns about the step for removing and installing the fuel pump for 2004 Audi A4 L4-1.8L Turbo (AMB) vehicle.
Removing And Installing Fuel Pump
CAUTION: To remove the Fuel Pump (FP), the fuel tank may only be filled to a maximum of 3/4. Empty fuel tank if necessary.
Empty fuel tank
Observe safety precautions.
Observe rules for cleanliness.
CAUTION: Observe safety precautions when disconnecting the battery.
(more…)

• 0 Comments

The AirDog® Fuel Air Separation system is a Premium replacement lift pump and filtration system for the Dodge Cummins diesel engine. A complete installation kit is included. The AirDog® delivers clean fuel to the engine free of virtually all air/vapor and at a positive flow. Thus, allowing the engine “test cell” performance and efficiency, while in “real world” use. The AirDog® FP-100 flows 100 GPH and is recommended for stock and slightly modified 6.7L Cummins Diesels up to 550 HP. The AirDog® FP-150 is recommended for highly modified 6.7L Cummins Diesels up to 1,200+ HP. PureFlow products are manufactured with a personal touch, unsurpassed attention to detail and the most stringent quality control.
(more…)

• 0 Comments

PRE-INSTALLATION NOTES.
Refer to OE service manual for proper disassembly/assembly procedures for OE components (like steering shaft, anything else). Consult following instructions for special tools necessary for this installation. Compare parts included in your system with the enclosed parts list. Placing hardware with components before you start may reduce installation time. Contact your Trail Master dealer if any parts are missing or appear to be different than those indicated on the parts list.
(more…)

• 0 Comments

Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame Unobstructed.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may be necessary to drive the vehicle until fuel is as low as possible in the tank.
3. Disconnect 1 ―” fuel tank full hose and ū” vent line hose from fill spout, leaving them attached to the tank
4. Disconnect electrical connection, feed line and return line from the sending unit. Press in the tabs on the connection fittings to release fuel lines.
(more…)

• 0 Comments