Pillar Installation Instructions:
1)  Remove Stock Pillar by  removing the two  screws  located under the caps of pillar  handle.
2)  Install Gauges in new pillar.
3)  Tape  or secure gauge wiring to back of  pillar.
4)  Install new pillar in place of old pillar.
5)  Use  provided screw to hold pillar in place:
  •  Make sure screw is aligned with factory hole to avoid cross threading
  •  Don’t over tighten screw
(more…)

• 0 Comments

First, please accept our most sincere “thank you” for choosing this part. In your hands rests the results of a lot of hard work and commitment to standing out in a crowded aftermarket. Your choice in our products allows us to continue to work towards developing more unique and innovative solutions for your performance needs.
(more…)

• 0 Comments