1. Module Installation: You will need to run the wiring harness thru the firewall and attach your power module to the harness inside the cab of your truck. Place the module under the dash out of the way
of your pedals.
2. Data Link Connection: The Data Link connector is located in different locations based on the year of the truck.
98.5-99: The triangle shaped connector is located on the driver’s side of the engine in the wiring harness near the power steering pump.
2000-2002: The three prong flat connector is located on the top of the fuel lift pump that is located on the driver’s side of the engine directly below the map sensor.
Note: on some 2001 trucks the connector is located on the driver’s side of the engine in the wiring harness near the power steering pump.
(more…)

• 0 Comments

Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover. Data Link Connection
2. The Data Link connector is located in different locations based on the
year of the truck:
• 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump
• 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump
3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector.
(more…)

• 0 Comments

The GROM iPod adapter is designed to provide endless hours of listening pleasure through most vehicles factory radio. To insure that your iPod performs correctly in your car or truck, we recommend that you read this entire manual before attempting install the GROM interface.

Proper mounting location
Securely install the interface in a location free from; heat, humidity, moving parts or direct sunlight. Beware of hot-air flow from your vehicle’s climate control system. We recommend securing the interface to a suitable location, free of sharp metal edges, using double sided tape, Velcro or wire ties.
(more…)

• 0 Comments