Prep Work And Check List
Clean the Surface of the Box sides on your truck with denatured alcohol or wax remover. It is IMPORTANT that the surface is clean so that our Box seal will adhere properly to the Truck box.

Install Rails And Seals
1. There are two rails. Put the rail with the 3rd leg hinge clamp (Fig.1) closest to the cab on the bed rail. Make sure the rail is as close as possible to the cab. Remove the blue paper. Push the rail down, then do the same for the other side.
2. To clamp the rail on the truck bed use a 5/16” socket, wrench or drill then tighten the screws on clamps. Be careful not to over tighten! (Fig 2.) You may use the preset spots on each rail.
(more…)

• 0 Comments

Step 1-Unpack QuickLIFT kit and verify contents.
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas Charged Springs
* (4) 3/16″ multi-grip rivets – used on hood brackets
* (4) Self tapping high strength screws – used on fender brackets
* (4) Fender & Hood Steel brackets
* Printed Instructions
* Gas Spring locking clips (already installed on the gas spring ball ends – Remove before assembly – DO NOT LOSE, these are very small and disappear if dropped.)
(more…)

• 0 Comments

First, please accept our most sincere “thank you” for choosing this part. In your hands rests the results of a lot of hard work and commitment to standing out in a crowded aftermarket. Your choice in our products allows us to continue to work towards developing more unique and innovative solutions for your performance needs.
(more…)

• 0 Comments