Installation for 2001-2003 Acura 3.2CL Cold Air System:
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments

TO START the Installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Remove the four 13mm nuts that secure the strut toner brace to vehicle, then remove brace from vehicle.
3. Squeeze the two locking tabs together, then remove the mass air electrical connection as shown.
4. Loosen the hose clamp at the intake plenum and release the two clips that secure the air box lid to vehicle, then remove the upper air box and intake tube as shown.
(more…)

• 0 Comments

The K&N intake tube installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen hose clamp at the mass air, then remove the three 10mm bolts that secure air box to vehicle.
4. Remove air box from vehicle as shown.
(more…)

• 0 Comments

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamp on the intake tube at the throttle body.
4. Loosen and remove the bolt that secures the air cleaner assembly to the inner fender.
5. Detach the crank case vent hose from the intake tube.
(more…)

• 0 Comments

Installation Step:
1. Disconnect the negative battery cable! Push the green tab on the crankcase breather tube, and disconnect it from the air intake tube. Loosen one hose clamp on each end of the air intake tube and remove it from the vehicle.
2. Remove the four bolts that hold the throttlebody to the intake manifold.
3. Install the ECONOAID Plate against the manifold with the logo facing the throttlebody. Next install the supplied gasket between the ECONOAID Plate and the throttlebody.
(more…)

• 0 Comments