These tools are designed to remove and install front wheel drive front wheel bearings. It is not necessary to remove the knuckle assembly from the vehicle, and, as a result, front wheel alignment is not altered.
Vehicle Setup
1. Raise the vehicle until all weight is off the front wheels, and they hang freely.
2. Remove the following components: • front tires • axle nut • outer tie rod nut and tie rod • disc brake caliper – use a wire (or OTC No. 7661 caliper hanger set) to hold caliper out of the way and prevent damage to brake hose • brake rotor • loosen the lower ball joint from the steering knuckle assembly
3. Lubricate the forcing screw in the tool set.
(more…)

• 0 Comments

This pdf covers the removal & installation the timing case cover for Chevrolet S10 Pickup.
Removal
1. Disconnect negative battery cable. Remove P/S reservoir from radiator shroud. Remove upper fan shroud. Remove serpentine belt.
2. Remove generator with brackets and lay aside. Using Hub Puller (J-24420-B), remove crankshaft pulley hub. Remove oil pan. See OIL PAN. Remove front timing case cover bolts, and cover.
3. Using large screwdriver, remove crankshaft front seal. DO NOT distort timing gear cover during seal removal.
CAUTION: To prevent oil leakage, coat crankshaft pulley hub keyway with RTV sealant before installation.
(more…)

• 0 Comments