This coil spring lift kit should only be installed on vehicles in good working condition. Before installation, the vehicle should be thoroughly inspected for evidence of corrosion or deformation. This coil lift kit should not be installed on any vehicle that is suspected to have been in a collision or misused. Failure to observe this warning may result in serious personal injury and/or severe damage to your vehicle.
(more…)

• 0 Comments

Hotchkis Tuning recommends that this sway bar set be installed by a professional, as the front sway bar can only be removed or installed by detaching the front engine cradle and lowering it from the vehicle!
Tools required for this installation:
- Hydraulic jack, jack stands, torque wrench
- The following sockets or wrenches: 12mm, 14mm, 17mm, 19mm
▪ The following Allen wrenches: 6mm
- Suggested tools: 6” socket extension, swivel ratchet
(more…)

• 0 Comments

This kit was designed for use with TM Kit# F4531. Use of this kit with other suspension kits and shocks, including coilovers, has not been verified. Proceed with caution. Interferences may exist. This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal. If the vehicle is suspected to have been in a collision or misused, do not install this kit. Off-road use of your vehicle with this kit installed may increase the stress applied to the factory components. Failure to observe this warning may result in serious personal injury and/or severe damage to your vehicle.
(more…)

• 0 Comments

FRONT INSTALLTION INSTRUCTIONS
1. Block the rear wheels of the vehicle. Raise the front of the vehicle and support the vehicle with jack stands under the frame rails. Remove the front wheels and tires and set aside. Position a hydraulic jack under the front axle and raise the jack until the front suspension begins to compress.
2. On both sides of the vehicle, scribe alignment marks on the adjustment cam and axle bracket at the lower link to axle attachment point for later reference. See Photo 1
(more…)

• 0 Comments

Prepare to Install Kit
1. Front axle
a. If equipped, remove two caps (4) from front wheels (5).
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front axle (7) so that two front tires (8) are three to five inches off of ground. Position jack stands under frame (9). Lower frame onto jack stands. DO NOT remove hydraulic jack and maintain some hydraulic jack pressure on axle.
d. Remove eight lug nuts (6) each and two front wheels (5) from axle (7)
(more…)

• 0 Comments