Removing original inlet hose intact (can be reused)
1. Follow factory service manual for intake manifold removal.
2. Remove original inlet hose.
3. Install PERRIN inlet hose.
4. Re-install intake manifold in reverse order.
5. See instruction on page (2) for hose connections and routing to the PERRIN inlet hose.
(more…)

• 0 Comments

This inlet pipe kit may require the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
Getting started
Make sure vehicle is parked on a level surface. Set parking brake. Disconnect negative battery terminal. If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments

The AEM Cold Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced Cold Air Intake System on the market. Each system is specifically engineered for its application. All AEM Cold Air Intake Systems deliver maximum performance gains through lightweight, all-aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range. Unlike plastic systems that use a continually diverging cross-section, we take advantage of the acoustical energy in the inlet duct to promote cylinder filling during the intake valve-opening event. Every intake is coated with a high-gloss, heat-reducing Zirconia based powder coating.
(more…)

• 0 Comments

Installation instructions on Nissan 350z5:
1. Raise and support vehicle.
2. Lubricate stock rubber hangers with penetrating oil.
3. Remove electrical ground strap from muffler.
4. Remove fasteners attaching stock Y-pipe inlet flanges to mating flanges on converter outlet pipes.
5. Remove fasteners attaching Y-pipe outlet flange to mating flange on exhaust mid-pipe. Remove Y-pipe from vehicle.
6. Loosen but do not remove fasteners that fasten catalytic converters to stiffener bracket that is attached to transmission bell housing.
(more…)

• 0 Comments

This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
1) Getting started Make sure vehicle is parked on a level surface. Set parking brake. Disconnect both battery terminals. If engine has run within the past two hours let it cool down. 2) Removing the stock air inlet system a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process. There are two Vacuum Switching Valves (VSV), and one air flow (more…)

• 0 Comments

Read and understand these instructions BEFORE attempting to install this product.
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments

Installation for 2001-2003 Acura 3.2CL Cold Air System:
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments