EGR SYSTEMS: This manifold will not accept stock EGR (exhaust gas recirculation) equipment. EGR systems are used on some 1972 and later
model vehicles and only in some states. Check local laws for requirements. This manifold is a street legal replacement part when used with the OEM carburetor on 1968-72 472 and 500 c.i.d. V8 passenger cars.
• MANIFOLD: The Performer Cadillac is intended to be used in high performance and engine swap applications. The carb pad is 3″ taller than stock, and will not fit many stock applications. Check your hood clearance before installation! The manifold accepts either original equipment Q-Jet carburetors or Edelbrock Performer Series square-bore carbs as listed below. The runners and plenums are sized for operation from idle to 5500 rpm on 500 c.i.d. engines.
• CARBURETOR RECOMMENDATIONS: CAUTION- Use only carburetors recommended. If parts required for installation are unavailable locally, contact Edelbrock directly.
(more…)

• 0 Comments

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
(more…)

• 0 Comments

Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Installation Procedure:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching throttle body to manifold.
4. Lift throttle body.
(more…)

• 0 Comments

Step of the Installation Instructions:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and carefully pull and remove the air box. * Be careful not to drop anything in the oil filler pipe.
(more…)

• 0 Comments

Read and understand these instructions BEFORE attempting to install this product.
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments

The installation instructions step:
1. Disconnect the negative battery cable! Loosen two hose clamps and remove the air intake tube. Separate the intake tube from the plastic clamp on the upper radiator hose. (If equipped).
2. Using a 10mm socket, remove the three nuts that hold the throttle body to the intake manifold.
3. Using a 4mm socket, remove the three studs that go thru the throttle body into the intake manifold.
(more…)

• 0 Comments

Installation Step:
1. Disconnect the negative battery cable! Push the green tab on the crankcase breather tube, and disconnect it from the air intake tube. Loosen one hose clamp on each end of the air intake tube and remove it from the vehicle.
2. Remove the four bolts that hold the throttlebody to the intake manifold.
3. Install the ECONOAID Plate against the manifold with the logo facing the throttlebody. Next install the supplied gasket between the ECONOAID Plate and the throttlebody.
(more…)

• 0 Comments