Additional Parts needed when you have a Dragon Filter, 1 x 3″-3″ Coupler / 2 x 3″ Clamp Remove bolts securing OEM air cleaner box, loosen clamps on OEM rubber intake pipe. Remove the coolant transfer / PCV hardline from from OEM intake and engine. Mark the coolant tranfer hose origins, install the 10mm hose supplied in kit to those 2 locations. Remove the OEM rubber intake tube, remove the OEM air cleaner box by pulling upwards. Wipe the throttlebody clean of any grease, install the 2.5″-3″ coupler onto throttlebody, secure with OEM clamp. Insert Weapon*R intake pipe into the 3″ end of the 2.5″-3″ coupler, secure with clamp. Measure the OEM PVC hose, replace with supplied 10mm (more…)

• 0 Comments

This GReddy Intercooler Kit is designed only for the Nissan 350z chassis Z33, with GReddy Turbo Kit (part # 11520093) installed. Premium grade gasoline (91 octane or higher) is required with this Kit. Make sure that the vehicle is not equipped with any ECU upgrade chips. Use of GReddy Racing Spark Plugs ISO #7 LONG or NGK plugs (colder than factory) is recommended with this kit.
(more…)

• 0 Comments

This performance kit installation steps on Audi A3: 1. Disconnect the negative terminal from the vehicle battery. 2. Remove the plastic engine cover. (Fig. 1) 3. Unclip & remove the engine breather hose from the intake pipe. (Fig. 2) 4. Remove the small vacuum hose from under the breather hose on the intake pipe. Follow the vacuum hose & remove the hose from the inlet manifold. Blank off the pipe on the manifold using the small rubber cap supplied. (Fig. 3) 5. Remove the small rubber hose from the side of the intake pipe as shown. (Fig. 4) 6. Unclip & remove the auxiliary air pump feed pipe from the air box as shown. (Fig. 5) 7. Unclip & remove the plastic intake pipe from the throttle housing. (Fig. 6) 8. Remove the air box securing bolt & carefully pull the air box assembly out of its mounting grommets. Remove the air box (more…)

• 0 Comments