Front Door Installation for Magnum, Charger, 300C
1. Using a pick tool pry open the screw covers behind the interior door release lever and below the
arm rest and remove the screws. Fig. 1
2. Remove the four screws securing the door panel along the bottom. Fig. 1
3. Using the end of a Phillips screwdriver gently depress the center pin of the three plastic retainers
securing the door panel. The center pin of the plastic retainer should depress approximately 1/8”
and allow the retainer to be removed from the door panel. The two uppermost retainers do not
need to be removed in order to remove the door panel. Fig. 2
(more…)

• 0 Comments

Removal All Vehicles
1. Remove the rear door interior trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
2. Remove the access hole watershield.
3. Reconnect the window regulator and window switch electrical connectors and position the front door window to access the glass clamp bolt.
4. Disconnect the window regulator and window switch electrical connectors
5. Loosen the window glass clamp bolt.
(more…)

• 0 Comments

Front Door Installation for Magnum, Charger, 300C
1. Using a pick tool pry open the screw covers behind the interior door release lever and below the arm rest and remove the screws.
2. Remove the four screws securing the door panel along the bottom.
3. Using the end of a Phillips screwdriver gently depress the center pin of the three plastic retainers securing the door panel. The center pin of the plastic retainer should depress approximately 1/8” and allow the retainer to be removed from the door panel. The two uppermost retainers do not need to be removed in order to remove the door panel.
(more…)

• 0 Comments

Neon Front Door Instructions:
1. Using a pick tool pry open the screw cover behind the interior door release lever and remove the screw.
2. Remove the screws in the armrest pocket and at the top of the door near the front.
3. For models with manual windows use a window crank removal tool to disengage the pin securing the window
crank and pull the window crank from the door. The triangle shaped piece that houses the side mirror
adjustment control lever will need to be pulled away from the door. Using a panel removal tool gently pry
the bottom of the plastic away from the door to release the fasteners and let it hang by the mirror control cables.
(more…)

• 0 Comments

General notes before you use your new parts …
1. The new Bugatti door handles you have purchased are an exclusive product of Model Motorcars, Ltd., based entirely on proprietary research of prototypes and exclusive miniature manufacturing technology, and are only available through us. Please beware of imitations and copies.
2. Our Bugatti door handles are designed to be used as a substitute for the Pocher supplied parts, although some work to modify the doors to adapt the handles is required. Therefore, they are only suggested for experienced Pocher builders adept at modify the kits extensively.
(more…)

• 0 Comments