REMOVAL NOTE: Perform the work with the engine installed to body when replacing a single part. 1) Remove the V-belts. 2) Remove the crank pulley. 3) Remove the timing belt cover. 4) Remove the timing belt. 5) Remove the actuator cover of the intake cam sprocket. 6) Fasten the cam sprocket and remove from the cam shaft using ST. ST 499207400 CAM SPROCKET WRENCH
(more…)

• 0 Comments

Wiper and Washer System — Front Item Part Number Description 1 W707014-S441 Wiper pivot arm nut 2 17526 Wiper pivot arm (LH and RH) 3 N807391 Wiper pivot arm linkage bolt (3 required) 4 17508A Wiper pivot arm linkage assembly (includes wiper motor) 5 — Wiper motor crank bolt 6 — Wiper motor attachment bolt (3 required) (Continued) 7 17508B Wiper motor 1 W708312 Wiper pivot arm nut 2 17526 Wiper pivot arm (more…)

• 0 Comments

INSTALLATION NOTES
1. Unless specified, mount all Sub-Frame components to vehicle before tightening any bolts.
2. Vehicle should be parked on a level surface with the
front suspension normally loaded.
MOUNTING INSTRUCTIONS
1. Locate existing slotted holes in vehicle frame rails directly above front axle.
2. Install Mounting Bracket (#3)RH, using three (3) 5/8″ x 2″ Capscrews (#10) Washers, and Nylock Nuts provided.
(more…)

• 0 Comments

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Insert pairs of 5/8 inch x 7 1/2 inch and 5/8 inch x 8 inch hex bolts through holes in four 1/2 inch thick top bars from the kit. Place the 7 1/2 inch bolt/bar assemblies over the side rails of the vehicle ahead of the cab mount structure. Place the 8 inch bolt/bar assemblies over the side rails behind the cab mount structure.
(more…)

• 0 Comments