Models: 6405/4410 & 6405/4410TK GM/Chevrolet 2007 – current (new body style) full size trucks and SUVs with manual power mirrors.
THIS SET IS DESIGNED FOR TRUCK WITH STOCK MANUAL MIRRORS. IF YOU CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED.
(more…)

• 0 Comments

Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt.
Remove negative battery cable from terminal and position away from battery.
4. Wait one (1) minute prior to working on the vehicle to assure SIR roof rail airbag system has been disabled for your safety. Install Camera into Endgate
(more…)

• 0 Comments

The polished black cover on each mirror can be removed and painted to match the vehicle’s body color, or replaced with chrome (p/n 9040) or ‘USA Flag’ theme covers (p/n 9060). Find below the removal/installation instructions for the cover.
Existing cover removal.
Make sure you have the required tools:
• flashlight
• slotted screwdriver (with at least a 5” shaft).
Approximate installation time: 5 –10 minutes.
(more…)

• 0 Comments

REMOVAL OF EXISTING MIRRORS
1. Have both windows in the down position. To remove the trim panel on both doors, first remove the panel around the door handle, using 10 mm socket remove the screw holding the door handle. Next remove the four screws that hold the door trim panels in place (See diagram A on page 5). Remove the door trim panel by lifting up and then out.
2. Unplug the electric cord that comes from the mirrors located at the rear of each mirror at the mirror mount area.
3. Support the stock mirror while removing the 3 mirror mount lug nuts using a 10 mm socket. Save the stock nuts for later in the install.
4. Remove the stock mirror (save the stock gaskets as they will be re-used).
(more…)

• 0 Comments