1. Unclip and remove the MAS (Mass Air Sensor) from the intake hoses.
2. Unclip and remove the electrical harness plug from the MAS and remove the MAS from the car.
3. Unscrew and remove the complete air box assembly.
(more…)

• 0 Comments

This mount bar has been designed to provide a mounting point for the shoulder straps of a 5 or 6 point off road harness system. Note: loctite on all threads is recommended. Steps (1 – 7) are for installing the rear mounting brackets. These brackets remain in the vehicle so these steps are done just once.
Step 1. Remove rear lower seat cushion lift up at lower edge as shown.
Step 2. Remove outside seat back cushions. Carefully pull at top rear edge, rotate & pivot to clear lower pivot pin.
Step 3. Remove rear inside 1/4 panels carefully – pop out.
Step 4. Remove outside rear seat belt buckle, mounting bolt and washers.
(more…)

• 0 Comments

TO START:
1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the mass air sensor wiring from the engine cover.
3. Remove the two screws shown that secure the fresh air tube to the fresh air duct.
4. Pull up firmly on the air filter housing/engine cover assembly to release it from the mounting grommets.
NOTE: The air filter housing/engine cover assembly is still attached to the intake inlet tube.
5. Using pliers, release the spring clamp that secures the intake to the intake inlet. Then unhook the intake tube from the inlet.
(more…)

• 0 Comments