Remove Plugs – Driver’s Side
Counting from the front, locate the third (3rd) and seventh (7th) plugs on the inner sill for a Quad Cab. For a Mega Cab locate the third (3rd) and eighth (8th) plugs. Use a flat screwdriver to pry them out

Assemble Rear Mounting Bracket Assembly – Driver’s Side
Locate the Rear Mounting Brackets and the Mounting Bracket Support Nuts in the parts kit. Use a Medium Hex Bolt to attach a Support Nut to the back of the Rear Mounting Bracket. If you have a Mega Cab, remove the tape and cut as indicated for the Mega Cab Rear Bracket, if necessary.
(more…)

• 0 Comments

Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2. Remove the exhaust system from the rubber insulators and remove all of the clamps from the catalytic converter back.
3. Separate the slip joint behind the muffler and remove the tail pipe. Next, separate the slip joint located behind the catalytic converter and remove the muffler and extension pipe.
(more…)

• 0 Comments

This mount bar has been designed to provide a mounting point for the shoulder straps of a 5 or 6 point off road harness system. Note: loctite on all threads is recommended. Steps (1 – 7) are for installing the rear mounting brackets. These brackets remain in the vehicle so these steps are done just once.
Step 1. Remove rear lower seat cushion lift up at lower edge as shown.
Step 2. Remove outside seat back cushions. Carefully pull at top rear edge, rotate & pivot to clear lower pivot pin.
Step 3. Remove rear inside 1/4 panels carefully – pop out.
Step 4. Remove outside rear seat belt buckle, mounting bolt and washers.
(more…)

• 0 Comments