These instructions are guidelines only and in no way are intended to replace a professional installation. As always before screwing or drilling check to make sure you will not damage any wires or hoses or cause damage to the vehicle.
Warning: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When charging or working near a battery, always shield your face and protect your eyes. Always provide ventilation.
(more…)

• 1 Comment

Remove the front bumper cover
A. Begin by removing the dust covers that are located underneath the vehicle. Use the 10mm socket to remove the OEM bolts and then the 7mm Nut driver to removed all the OEM screws along the sub-front portion of the bumper.
B. Locate and remove all other fasteners that attach the OEM bumper cover to the vehicle. Once you’ve removed the fasteners, slowly remove the bumper cover. Note that some vehicles may have the foam bumper protector inside, where some may have the plastic protector. The Pro-gard Push Bumper was designed for the plastic protector.
(more…)

• 0 Comments

We hope you are satisfied with the look and performance. You may use any polish or wax on the pipe as it’s painted with the same high quality paint as your car. Please note, with such a large pipe the fit is tight. Take your time and it will be a smooth install. Please note, it has come to our attention that Ford has 4 different motor mounts putting the engine in 4 slightly different positions. This can cause this intake to be very tight to the oil fill cap on a small percentage of models and “may” require slight modification of the cap with a Dremel or grinder to clear this JLT intake.
(more…)

• 0 Comments