THESE STEPS MUST BE PERFORMED IN THE FOLLOWING ORDER:
1. Place the motorcycle on its centerstand on level ground and lift the front seat. Remove the (2) bolts that hold the rear seat in place with a 5mm Allen wrench. Remove the seat and set it aside.
2. Lift the trunk lid and have your assistant hold it open, Remove the screw that hold the retractable cord in place and let the cord retract into its reel. CAUTION: DO NOT LET THE LID FALL FORWARD, DAMAGE MAY OCCUR.
(more…)

• 0 Comments

1. Disconnect the negative battery terminal.
2. Unclip and remove the electrical plug from the MAS (Mass Air Sensor).
3. Remove the two screws securing the resonator tube to the air box lid.
4. Unclip and remove the intake hose from the MAS.
5. Undo the 2-air box mounting bolts and remove the air box from the vehicle.
6. Unbolt and remove the rear gearbox-mounting bolt as shown.
(more…)

• 0 Comments

INSTALLATION NOTES
1. Unless specified, mount all Sub-Frame components to vehicle before tightening any bolts.
2. Vehicle should be parked on a level surface with the
front suspension normally loaded.
MOUNTING INSTRUCTIONS
1. Locate existing slotted holes in vehicle frame rails directly above front axle.
2. Install Mounting Bracket (#3)RH, using three (3) 5/8″ x 2″ Capscrews (#10) Washers, and Nylock Nuts provided.
(more…)

• 0 Comments

Step 1: Remove Trim Panel
-Start at the bottom edge of panel and gently pry out near storage pocket area. Move up to near the stereo and pry out again. The last two clips are at the top above the air vents, pry these out and the entire assembly will release.
-The climate controls are attached to the trim panel so next step is to remove the wiring clips from the rear of the unit. Now remove the wiring clips from the upper button assembly.
(more…)

• 0 Comments