Start by removing the factory pillar. This is done by pulling down the rubber door gasket and removing the two screws in the handle area of the pillar, tip the top towards the steering wheel to get it out. You have to use a little force to get it free of the dash.
Though the gauge pod is intended to be used as a replacement for the factory pillar, we suggest cutting the handle off of the factory pillar and using the gauge pod as a cover. This is so that the backs of the gauges will not be visible through the windshield after installation.
(more…)

• 0 Comments

Attached, for your reference, is a list of OEM paint codes for all 2001 – 2002 model year vehicles and 2003 model year Corolla and Matrix vehicles. NOTE: The body color code is on the vehicle Certification Regulation Label, located on the left front door “B” pillar or door rear lower surface. Please contact your local paint representative for the actual paint mixing formulas or if you need help in color matching.
- 2001 – 2002 model year vehicles, all models.
(more…)

• 1 Comment

Upper Windshield Glass Stoppers: 1. Remove both sun visors and both A-pillar garnishes, and then carefully lower the front of the headliner to gain access to the windshield stoppers (refer to the appropriate model year Repair Manual for the proper procedure). NOTE: It is very important that the front of the headliner be lowered carefully and slowly. Applying too much downward force on the headliner will cause it to develop a permanent crease in the surface material. The stoppers are located on the inside of the passenger compartment behind the windshield glass (more…)

• 0 Comments

With fuel consumption of just 5 8 litres per 100 km you get the maximum amount of power out of your fuel or as we say you ll drive every drop And it s all thanks to her amazing i VETC engine Now here s where we get down to the nitty gritty Her 1 3 litre i VTEC engine delivers 73kW of power while her 1 5 litre i VTEC engine delivers 88kW making her among the most powerful in her class.
(more…)

• 0 Comments

Front Door Installation for Magnum, Charger, 300C
1. Using a pick tool pry open the screw covers behind the interior door release lever and below the arm rest and remove the screws.
2. Remove the four screws securing the door panel along the bottom.
3. Using the end of a Phillips screwdriver gently depress the center pin of the three plastic retainers securing the door panel. The center pin of the plastic retainer should depress approximately 1/8” and allow the retainer to be removed from the door panel. The two uppermost retainers do not need to be removed in order to remove the door panel.
(more…)

• 0 Comments

Pillar Installation Instructions:
1)  Remove Stock Pillar by  removing the two  screws  located under the caps of pillar  handle.
2)  Install Gauges in new pillar.
3)  Tape  or secure gauge wiring to back of  pillar.
4)  Install new pillar in place of old pillar.
5)  Use  provided screw to hold pillar in place:
  •  Make sure screw is aligned with factory hole to avoid cross threading
  •  Don’t over tighten screw
(more…)

• 0 Comments

Neon Front Door Instructions:
1. Using a pick tool pry open the screw cover behind the interior door release lever and remove the screw.
2. Remove the screws in the armrest pocket and at the top of the door near the front.
3. For models with manual windows use a window crank removal tool to disengage the pin securing the window
crank and pull the window crank from the door. The triangle shaped piece that houses the side mirror
adjustment control lever will need to be pulled away from the door. Using a panel removal tool gently pry
the bottom of the plastic away from the door to release the fasteners and let it hang by the mirror control cables.
(more…)

• 0 Comments