Speaker installation requires drilling two 13/32″ holes in the passenger side frame forward of the front wheel. To install the speaker, proceed as follows:
1. Locate the frame on the vehicle’s passenger side forward of the front wheel well. Before drilling or cutting holes in ANY part of a vehicle, be sure that both sides of the mounting surface are clear of parts that could be damaged; such as brake lines, electrical wiring or other vital parts.
(more…)

• 0 Comments

Installation Pro.Fit Kit on Ford Transit Connect. Place the DTRT and the Hook Tool in the space between the dash molding and the air vent bezel above and to the right of the radio. Use the hook tool first to gently pry up the air vent bezel sufficient enough to insert the DTRT. Use the DTRT in a gentle twisting motion around the bezel to release the eleven (11) retainer clips securing the air vent bezel to the dash molding. Place bezel off to the side. Insert four (4) Mercedes/Audi radio removal tools in the slots located in the four corners of the radio as indicated by the arrows in Picture 1. Follow radio removal instructions included with the radio removal tools part number (DM-20-22).
(more…)

• 0 Comments

STEP 1. Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece. Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do not disconnect the wiring . STEP 2. Under the temperature control module is a small black panel that is held in (more…)

• 0 Comments

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: #2 Phillips screwdriver, 5/64” drill bit, drill, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM, instructions, two (2) #10×5/8” screws.
LOCATION: Lower right corner of radio, below the radio.
(more…)

• 0 Comments