1. Before servicing the vehicle, refer to the Precautions section. 2. Remove or disconnect the following: • Negative battery cable • Transfer case, if equipped • Transmission 1 • Pressure plate. Loosen the bolts evenly in /2 turn steps. • Clutch disc To install: 1. Install or connect the following: • Clutch disc and pressure plate. Tighten the pressure plate bolts evenly in /2 turns to 23 ft. lbs. (31 Nm) for 2.4L and 2.5L engines; 37 ft. lbs. (50 Nm) for 4.0L engines. • Transmission • Transfer case, if equipped • Negative battery cable
(more…)

• 0 Comments

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual)
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
3. Remove tether bolt. A special wrench may be required.
4. Remove latch pin bolt. A special wrench may be required.
5. Figures 1 through 5 show the three styles of TireGates
6. Install the supplied pivot cups and the right and left OEM pivot cups in the left and right side uprights. See Figure 6.
(more…)

• 0 Comments

This mount bar has been designed to provide a mounting point for the shoulder straps of a 5 or 6 point off road harness system. Note: loctite on all threads is recommended. Steps (1 – 7) are for installing the rear mounting brackets. These brackets remain in the vehicle so these steps are done just once.
Step 1. Remove rear lower seat cushion lift up at lower edge as shown.
Step 2. Remove outside seat back cushions. Carefully pull at top rear edge, rotate & pivot to clear lower pivot pin.
Step 3. Remove rear inside 1/4 panels carefully – pop out.
Step 4. Remove outside rear seat belt buckle, mounting bolt and washers.
(more…)

• 0 Comments