1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the radio trim panel including the a/c vent. (Figure A) 3 Remove (4) 10 MM bolts securing the radio. Unplug and remove the radio.
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS
*Note: Refer also to the instructions included with the aftermarket radio.
1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel. (Figure A)
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
(more…)

• 0 Comments

Installation Instructions. Read Me! Rv. 01/04
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (3) nuts & studs from the throttle body & manifold. (Ref. “C”)
4. Remove support bracket from engine block to throttle body. (Ref. “D”)
* Please Note: When removing support bracket bolt at engine block, loosen bolt enough to remove bracket. DO NOT REMOVE BOLT.
(more…)

• 0 Comments