Before beginning this installation, take a few minutes to preread these instructions. Check that all necessary materials, units and accessory kits that are listed in the application guide are on hand. It is imperative for proper engine operation and vehicle life that adequate engine cooling is provided (i.e. fan shroud and/or large fan). Also check the vehicle weight capacity as listed on the vehicle certification label. Advice is hereby given by the vehicle manufacturer that for proper driving and handling, the reserve weight capacity not be exceeded, refer to the manufacturer recommended sizing guide
(more…)

• 0 Comments

The installation instructions step:
1. Disconnect the negative battery cable! Loosen two hose clamps and remove the air intake tube. Separate the intake tube from the plastic clamp on the upper radiator hose. (If equipped).
2. Using a 10mm socket, remove the three nuts that hold the throttle body to the intake manifold.
3. Using a 4mm socket, remove the three studs that go thru the throttle body into the intake manifold.
(more…)

• 0 Comments

1. Start by supporting the car on 4 jack stands. The car should be sitting on approximately the same angle as it does on the ground, or slightly lower in front.
2. Remove all the old front suspension components. Note that on the underside of the frame are the two rubber axle snubbers (or the holes for them, if they are missing) directly above the axle. Mark them for later reference.
3. We would recommend that at this point, you tack weld or clamp a temporary brace across the frame rails in front of the old crossmember as shown in
Figure 1. This helps to maintain the rail dimension after the old crossmember is removed.
(more…)

• 0 Comments