KIT FEATURES
• DIN Radio Provision with pocket
• ISO Radio Provision with pocket
• Double DIN Radio Provision
• Stacked ISO Units Provision
A) Radio Housing B) ISO Snap In Brackets C) Trim Plate D) Double DIN Brackets E) Double DIN Trim Plate F) Pocket
(more…)

• 1 Comment

1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the radio trim panel including the a/c vent. (Figure A) 3 Remove (4) 10 MM bolts securing the radio. Unplug and remove the radio.
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS
*Note: Refer also to the instructions included with the aftermarket radio.
1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel. (Figure A)
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
(more…)

• 0 Comments

Dash Assembly: 1 Disconnect the negative battery-terminal to prevent an accidental short circuit. 2 Unsnap the trim below the climate control to reveal (2) 10 MM bolts and remove. (Figure A) 3 Carefully pull air vents above radio towards rear of car to unsnap. NOTE: There are (3) snaps, (2) are at the bottom sides and (1) is at the top middle of the vent assembly. (Figure B) 4 Remove (2) 10 MM bolts from above radio/climate control assembly. Unplug and remove assembly together. (Figure C) 5 Remove (6) Phillips screws (4 from radio and 2 from climate control) from each side bracket to separate radio and climate control. (Save climate controls and brackets to reuse during kit assembly). (Figure D) Continue to kit assembly.
(more…)

• 0 Comments