Installation Note: This vehicle is designed with 2 different radio styles. Each radio design requires a completely different method of installation for a new replacement radio. The most important thing to understand is the difference between the plastic dash panel that surrounds the 2 different radio styles. This plastic dash panel actually dictates how you install your new replacement radio. Read below to find out why.
(more…)

• 0 Comments

Remove Factory Radio
STEP 1: Locate and remove two (2) phillips screws that secure the top of the plastic panel that covers the radio and air conditioner controls. They should be located next to the air conditioner vent levers directly above the (2) air conditioner vents. Pull the plastic panel gently from the top to remove it from the dash.
STEP 2: The radio will be held in with two (2) 7mm bolt screws; one on each side of the radio. Remove both.
STEP 3: To remove the radio, pull firmly. Unplug all connectors (1 blue, 1 white, 1 black) from the rear of the radio. Unplug the antenna cable from the rear of the radio. The radio is now free to be removed from the dash panel.
STEP 4: Since the opening is so big in the dash, The Install Doctor recommends using the plastic mounting bracket attached to the bottom of the radio just removed.
This bracket can then be attached to the bottom of the plastic radio installation kit and assure that this kit is properly aligned and secured to the dash.
(more…)

• 0 Comments