This chapter provides information required for the installation of the Neo iON, it must be read by all users. Thank you for purchasing the Neo iON. Since the Neo iON works in many different vehicles the following steps must be taken to ensure the iON is set up correctly for the vehicle it is being installed in.
(more…)

• 0 Comments

Before beginning repairs on the electrical system: Obtain the anti-theft radio security code. Switch the ignition off. Disconnect the battery Ground (GND) strap. On vehicles equipped with Audi Telematics by OnStar , switch-off the emergency (back-up) battery for the Telematic/Telephone Control Module prior to disconnecting vehicle battery Repair Manual, Communication, Repair Group 01 .
(more…)

• 0 Comments

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
TOOLS REQUIRED: #2 Phillips screwdriver, 5/64” drill bit, drill, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM, instructions, two (2) #10×5/8” screws.
LOCATION: Lower right corner of radio, below the radio.
(more…)

• 0 Comments

RaDIo FuncTIonS:
• How to get to the XM band
– Select XM1 or XM2 with the BAND button
• Tuning in XM channels
– Scroll through XM channels with the TUNE knob
– When you change channels, the radio will display the Channel Number/Name, then revert to the default display
– Press SEEK once to select the next channel, or press and hold for 2 seconds to scan through all channels; SCAN will be displayed. Press and hold for 4 seconds to scan through all preset channels; SCAN and the preset number will be displayed
(more…)

• 0 Comments