Step Description
1. Place the vehicle on a hoist that leaves the entire underside of the frame Unobstructed.
2. Drain all the fuel from the original equipment tank using a pump or siphon. In some cases Dodge tanks have a screen at the tank inlet which won’t allow a siphon hose to enter. In this case, it may be necessary to drive the vehicle until fuel is as low as possible in the tank.
3. Disconnect 1 ―” fuel tank full hose and ū” vent line hose from fill spout, leaving them attached to the tank
4. Disconnect electrical connection, feed line and return line from the sending unit. Press in the tabs on the connection fittings to release fuel lines.
(more…)

• 0 Comments

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the vehicle.
6. Remove the complete airbox assembly from the vehicle as shown.
7. Remove the airbox mounting grommet as shown.
8. Install the large “L” bracket onto the heat shield with the provided hardware. NOTE: Do not tighten completely.
(more…)

• 0 Comments