Rear brakes – disc brake, servicing Rear brake – Girling disc brake for vehicles with Front and All-Wheel Drive, servicing Axle beam Hex socket head bolt, 10 Nm Wheel speed sensor For vehicles with ABS only Insert with solid lubricant G 000 650 Bracket for brake hose Hex socket head bolt, 65 Nm Hex bolt, self-locking, 35 Nm Replace When loosening and tightening, counter-hold at guide pin Guide pins Protective cap Brake pad securing spring Always replace when pads are replaced
(more…)

• 0 Comments

For rear disc pad removal and installation, DO NOT disconnect brake hose from caliper (wire aside). Replace all pads on an axle if wear indicator on any pad contacts rotor or if pad is worn to within .03″ (.8 mm) of pad backing.
Removal (”A”, “B”, “C”, “K” & “U” Series)
1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Remove wheel. Using “C” clamp, compress caliper piston until it bottoms out in its bore.
(more…)

• 0 Comments