1: Here is the Subaru WRX Lower Mesh Grille Kit Part# SUB-1712 available in silver or black finishes.
2: Here is our project WRX in need of a GrillCraft Mesh Grille for added protection and styling.
3: Start by removing the upper grille push down on retaining clips as shown.
4: There are two lower retaining clips down below a long screwdriver will release them.
5: Now the grille can be removed.
6: Remove bumper cover push clips.
7: Remove filler panel there is a push clip on the back side.
8: Remove headlamp in order to gain access to the clip behind it.
(more…)

• 0 Comments

The AEM Short Ram Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced short pipe air intake system on the market. Each system is specifically engineered for its application. All AEM Short Ram Air Intake Systems deliver maximum performance gains through lightweight, all- aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range. Unlike plastic systems that use a continually diverging cross-section, we take advantage of the acoustical energy in the inlet duct to promote cylinder filling during the intake valve-opening event.
(more…)

• 0 Comments

COWL TOP VENT PANEL
1. Remove windshield wiper pivot arms. Remove cowl top vent panel retaining screws. Release cowl top
vent panel retaining clips. Remove windshield wiper fluid hose. Remove cowl top vent panel.
2. To install, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE
SPECIFICATIONS INTAKE MANIFOLD
Removal
1. Remove cowl top vent panel. See COWL TOP VENT PANEL . Release fuel pressure and disconnect
(more…)

• 0 Comments

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Depress the locking tab on the mass air sensor electrical connection, then disconnect the\ mass air sensor electrical connection as shown.
3. Release the locking tab and disconnect the crank case vent tube as shown.
4. Loosen the hose clamp, which secures the intake tube to the throttle body, and release the air box over center clips shown.
5. Remove the air box housing half and intake tube as shown.
6. Remove the three body support brace mounting bolts shown and then remove the support brace from the engine compartment.
NOTE: It will be necessary to unhook the cruise control and wiring harness clips from the body brace.
(more…)

• 0 Comments

The AEM Cold Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced Cold Air Intake System on the market. Each system is specifically engineered for its application. All AEM Cold Air Intake Systems deliver maximum performance gains through lightweight, all-aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range. Unlike plastic systems that use a continually diverging cross-section, we take advantage of the acoustical energy in the inlet duct to promote cylinder filling during the intake valve-opening event. Every intake is coated with a high-gloss, heat-reducing Zirconia based powder coating.
(more…)

• 0 Comments