It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for bushing removal and install
of Energy Suspension polyurethane bushings, once you have removed the factory component from your vehicle.
1. Properly support the vehicle on the frame.
2. Remove the lower control arm. (Note: It is easier to remove the one bolt connecting the control arm to the spindle than it is to remove the three bolts that attach the ball joint to the control arm.)
(more…)

• 0 Comments

FRONT INSTALLTION INSTRUCTIONS
1. Block the rear wheels of the vehicle. Raise the front of the vehicle and support the vehicle with jack stands under the frame rails. Remove the front wheels and tires and set aside. Position a hydraulic jack under the front axle and raise the jack until the front suspension begins to compress.
2. On both sides of the vehicle, scribe alignment marks on the adjustment cam and axle bracket at the lower link to axle attachment point for later reference. See Photo 1
(more…)

• 0 Comments

PROCEDURES:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DRILLING MAY BE REQUIRED.
2. From underside the driver side front of the vehicle, remove the factory body mount bolt. Remove but do not discard the rubber bushing. Install (1) 12-1.75mm x 120mm Hex Bolt with (1) 12mm ID x 30.1mm OD x 3.1mm Flat Washer and (1) 12mm Lock Washer through the Driver Side Front Mounting Bracket. Position (1) Spacer Plate between the Mounting Bracket and the factory rubber bushing, (Figure 4). Slide the complete assembly up into position under the cab mounting bracket and thread the 12mm Hex Bolt into the factory mounting hole. Snug but do not tighten at this time.
(more…)

• 0 Comments