This performance kit installation steps on Audi A3: 1. Disconnect the negative terminal from the vehicle battery. 2. Remove the plastic engine cover. (Fig. 1) 3. Unclip & remove the engine breather hose from the intake pipe. (Fig. 2) 4. Remove the small vacuum hose from under the breather hose on the intake pipe. Follow the vacuum hose & remove the hose from the inlet manifold. Blank off the pipe on the manifold using the small rubber cap supplied. (Fig. 3) 5. Remove the small rubber hose from the side of the intake pipe as shown. (Fig. 4) 6. Unclip & remove the auxiliary air pump feed pipe from the air box as shown. (Fig. 5) 7. Unclip & remove the plastic intake pipe from the throttle housing. (Fig. 6) 8. Remove the air box securing bolt & carefully pull the air box assembly out of its mounting grommets. Remove the air box (more…)

• 0 Comments

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
(more…)

• 0 Comments