Volkswagen > A3 Platform > 1993 – 2002 5 Spd. Manual Transmission 020 34 – Manual Transmission – Controls, Housing Clutch housing, servicing 1 – Oil drain plug Without magnet 25 Nm (18 ft lb) 2 – Dowel sleeve Qty: 2 Shim S2 Always 1 mm thick (0.04 in.) 4 – Outer race of tapered roller bearing for differential Removing and installing => page 39-5 When replacing: adjust differential => page 39-17 5 – Magnet Retained in housing joint surface Install with AMV 188 200 03 sealant 6 – Shim S3 Adjustment summary => page 39-16 7 – Outer race for output shaft tapered roller bearing Removing and installing => page 35-14 When replacing: adjust output shaft => page 35-27 8 – Needle bearing for input shaft Removing => Fig. 1 Installing => Fig. 2 9 – Bolt With locking teeth 25 Nm (18 ft lb) 10 – Relay lever 11 – Spring 12 – (more…)

• 1 Comment

This pdf covers the removal & installation the timing case cover for Chevrolet S10 Pickup.
Removal
1. Disconnect negative battery cable. Remove P/S reservoir from radiator shroud. Remove upper fan shroud. Remove serpentine belt.
2. Remove generator with brackets and lay aside. Using Hub Puller (J-24420-B), remove crankshaft pulley hub. Remove oil pan. See OIL PAN. Remove front timing case cover bolts, and cover.
3. Using large screwdriver, remove crankshaft front seal. DO NOT distort timing gear cover during seal removal.
CAUTION: To prevent oil leakage, coat crankshaft pulley hub keyway with RTV sealant before installation.
(more…)

• 0 Comments

List of tools and additional parts required
Masking tape, clear tape, black mastic, hammer, centre punch
Assorted screw drivers, sockets and spanners
103mm (4”) hole saw
Assorted drill set, wet / dry sand paper, ½ round file, small square file,
Zinc rich primer.
(more…)

• 0 Comments