Section 1: Repair instructions for E36 1. Connect DIS/MoDiC 3 tester to a vehicle and read out SRS module fault code memory. If the above mentioned SRS faults are set in the airbag control module, proceed with the repair. 2. Remove corresponding front seat. For a removal instructions refer to RA 52 10 000 , or RA 52 10 001 (sports seat) which can be found in the Technical Information System (TIS). 3. Disconnect vehicle’s battery. 4. Remove cable securing wire ties (1), unplug the belt tensioner connector (2) from the belt buckle assembly and from the (more…)

• 0 Comments

Installation Procedure:
1. On left wall of trunk, remove the three fasteners that secure the trunk liner.
2. Remove Velcro attached net storage if equipped.
3. Open left rear passenger door fold down seat and remove two remaining fasteners that secure trunk liner.
4. Remove trunk liner.
5. Using Router Docking Station as a template, drill or punch four 1/8” diameter holes in level area near rear of trunk liner. Use caution-insulation located behind this area can bind in drill bit.
6. Attach docking station using four supplied nylon Key Hole clips.
(more…)

• 0 Comments