1994-95 models 2500 and 3500 with 5.9 diesel or 8.0 ltr. V-10, The vehicle manufacturer has a safety recall #835, which reinforces the coil towers. The part # for this upgrade is #CBBR8352. Check with your local dealer in regards to this upgrade prior to installing this suspension system.
-This supplement will be used when installing Platinum Series shocks and coils.
1. Platinum Series Coil Over Installation Guide.
(more…)

• 0 Comments

The front fascia, metal bumper, air baffle and windshield washer reservoir are removed for baseplate installation. Drilling is required. Trimming of metal bumper and fascia is required. Horn brackets will need to be relocated. The BX8869 is available for the vehicle. Attachment Tabs are 24 inches center to center and a height of 19 inches.
1. Remove the four phillips screws from top edge of upper grill between headlights, using the phillips screw driver.
2. Using a long shank phillips screw driver, loosen the screw on lower section of grill from opening on top edge of grill (white arrow), both sides. Pull the middle of top grill edge forward to loosen center screw of lower grill, pull grill forward and set aside.
3. Remove the five push pins from the top edge of fascia.
4. Remove one phillips screw from fascia’s end just forward of front tires, both sides.
(more…)

• 0 Comments

The mounting procedure outlined below covers the 1997-2002 Jeep Wrangler. Note that a
Front Gross Axle Rating (FGAWR) of 2500 lbs. is required. A suspension upgrade and additional
ballast may be necessary. You will need to refer to the illustrations and familiarize yourself with each
of the undercarriage components and their relative position to each other. Then proceed as follows:
Begin by removing the four screws that hold the plastic “Jeep” valance in place above the
bumper. Keep these screws as they will need to be reinstalled.
(more…)

• 0 Comments