This HowTo will go into the requirements, tools and procedure to remove and install a CAM on a Dodge 4.7 liter Engine.

Pre-Install Tips
Step 1
• Set TOP Dead Center (TDC) So V8 marks on both Sprockets are at 12 O’clock!/Crank balancer TDC mark should be aligned to TDC mark on block!
Step 2
• Mark One Link on Chain at (TDC) V8 marks with paint Pen!
Step 3
• Zip Tie Chain to Cam Sprockets (Through two holes in left sprocket and one hole in right sprocket)! Note: Do this after loosening sprocket bolt but before removing bolt and sprocket!
(more…)

• 0 Comments

First, please accept our most sincere “thank you” for choosing this part. In your hands rests the results of a lot of hard work and commitment to standing out in a crowded aftermarket. Your choice in our products allows us to continue to work towards developing more unique and innovative solutions for your performance needs.
(more…)

• 0 Comments