This B&M Precision Sport Shifter has been designed to work on most 1996-2003 Subaru Legacy & Impreza and 1996 and up Subaru Impreza WRX model vehicles. It has been engineered to greatly reduce shift throw and improve shifter feel. Check the parts and tools lists at the beginning of these instructions for the supplied parts and the tools required to install your B&M Precision Sport Shifter. Installation of this B&M Precision Sport Shifter can be accomplished by anyone with minimal mechanical experience.
(more…)

• 0 Comments

INSTALLATION Roof Rack on 2008 CR-V
NOTE: Be careful not to damage the roof and other finished surfaces of the body when installing the roof rack.
1. Using a flat-tip screwdriver wrapped with a shop towel, remove the four roof trim covers (four retaining tabs for each cover).
2. Clean the paint off of the mounting studs. Thread on a special nut until you feel resistance, then turn it an additional 90°. Remove the nut, and blow the nut and stud clean with compressed air. Repeat this process until the nut threads all the way on.
3. Repeat step 2 for all of the remaining studs.
(more…)

• 0 Comments

Tools needed:
Jack and axle stands
T25 Torx bit/screwdriver
Pliers
Flat and phillips head screwdriver
10mm socket & suitable ratchet
Dremel or Stanley knife
10mm spanner (ideally a ratchet spanner)

1. Jack the front of the car up and support it on axle stands so that the front wheels are clear of the ground and you can safely work underneath if necessary. Working on the drivers side, turn the wheels to the left and undo the T25 screw that holds the wing to the bumper.
2. Undo the two phillips head screws that hold the edge of the arch liner to the bumper, and the one screw that holds the back of the arch liner behind the wheel.
(more…)

• 0 Comments

Installation Instructions Procedures:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
(more…)

• 0 Comments

The installation instructions step:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner housing from throttle body.
3. Remove 5/16” bolt (Ref. “C”) & stud (Ref. “D”) from throttle body.
4. Remove (2) 6mm bolts from throttle linkage bracket and save.
5. Move the throttle body forward then remove the gasket and clean the surfaces.
(more…)

• 0 Comments

Installation for 2001-2003 Acura 3.2CL Cold Air System:
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
(more…)

• 0 Comments

1. Unclip and remove the MAS (Mass Air Sensor) from the intake hoses.
2. Unclip and remove the electrical harness plug from the MAS and remove the MAS from the car.
3. Unscrew and remove the complete air box assembly.
(more…)

• 0 Comments