Instructions Procedure:
1. Before beginning the installation, please read all directions carefully and verify that all necessary hardware is accounted for. If any parts are missing, stop the installation and contact your distributor immediately.
NOTE: The center channel/tube is installed in the lower position, if you install a winch higher than 11″ you can raise the central channel/tube to the next holes position.
2. If vehicle has factory tow hooks you must remove them. If vehicle has not factory tow hooks you must remove the plastic cover from the bumper. Image 1. NOTE: Tow hooks or plastic cover will not be reinstalled.
3. Locate the nuts and studs that secure the bumper bracket to the frame rail. Remove the (2) lower nuts.
(more…)

• 0 Comments

REMOVAL OF EXISTING MIRRORS
1. Have both windows in the down position. To remove the trim panel on both doors, first remove the panel around the door handle, using 10 mm socket remove the screw holding the door handle. Next remove the four screws that hold the door trim panels in place (See diagram A on page 5). Remove the door trim panel by lifting up and then out.
2. Unplug the electric cord that comes from the mirrors located at the rear of each mirror at the mirror mount area.
3. Support the stock mirror while removing the 3 mirror mount lug nuts using a 10 mm socket. Save the stock nuts for later in the install.
4. Remove the stock mirror (save the stock gaskets as they will be re-used).
(more…)

• 0 Comments

Before you begin installing this seat riser, please read all installation instructions and warnings thoroughly. This seat is designed to be used on the model vehicles described above. Use of this riser on any other vehicle or failure to install this seat properly may result in an improperly mounted seat and could result in unexpected movement of the seat and loss of control of the vehicle, thereby placing the occupants of the vehicle and others in a potentially dangerous situation.
(more…)

• 0 Comments

Trail Master recommends this system be installed by a certified technician! These instructions address installation of the Trail Master system and may not include OE recommended procedures for disassembly / reassembly of OE components. Research the areas requiring certification. In addition to these instructions, professional knowledge of disassembly / reassembly procedures as well as post installation checks are required. Attempts to install this system without knowledge and expertise may jeopardize the integrity and or operating safety of the vehicle.
(more…)

• 0 Comments

Installation Instructions. Read Me! Rv. 01/04
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (3) nuts & studs from the throttle body & manifold. (Ref. “C”)
4. Remove support bracket from engine block to throttle body. (Ref. “D”)
* Please Note: When removing support bracket bolt at engine block, loosen bolt enough to remove bracket. DO NOT REMOVE BOLT.
(more…)

• 0 Comments

The installation instructions step:
1. Disconnect the negative battery cable! Loosen two hose clamps and remove the air intake tube. Separate the intake tube from the plastic clamp on the upper radiator hose. (If equipped).
2. Using a 10mm socket, remove the three nuts that hold the throttle body to the intake manifold.
3. Using a 4mm socket, remove the three studs that go thru the throttle body into the intake manifold.
(more…)

• 0 Comments