INSTALLATION
NOTE: Be careful not to damage the tailgate and the body paint finish.
1. Open the tailgate. Insert a flat-tip screwdriver into the specified position of the right tailgate trim, and remove the pin as shown.
2. Remove the clip and remove the right tailgate trim.
3. Remove the left tailgate trim in the same manner.
4. Align the template with the left edge of the tailgate, and the front edge of the tailgate. Hold the template in place using masking tape. Mark the tailgate through the template using a felt-tip pen. Remove the template.
(more…)

• 0 Comments

Prep Work And Check List
Clean the Surface of the Box sides on your truck with denatured alcohol or wax remover. It is IMPORTANT that the surface is clean so that our Box seal will adhere properly to the Truck box.

Install Rails And Seals
1. There are two rails. Put the rail with the 3rd leg hinge clamp (Fig.1) closest to the cab on the bed rail. Make sure the rail is as close as possible to the cab. Remove the blue paper. Push the rail down, then do the same for the other side.
2. To clamp the rail on the truck bed use a 5/16” socket, wrench or drill then tighten the screws on clamps. Be careful not to over tighten! (Fig 2.) You may use the preset spots on each rail.
(more…)

• 0 Comments

1. Remove tailgate by disconnecting the tether cable and lifting the tailgate out at approximately a 45º angle. (Reference the truck’s Owner’s manual)
2. Carefully remove the OEM tailgate pivot cups from the tailgate taking note of which side they belong on.
3. Remove tether bolt. A special wrench may be required.
4. Remove latch pin bolt. A special wrench may be required.
5. Figures 1 through 5 show the three styles of TireGates
6. Install the supplied pivot cups and the right and left OEM pivot cups in the left and right side uprights. See Figure 6.
(more…)

• 0 Comments